Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 16 Next »

Overview

Birck supplies a selection of photoresists for both optical and electron beam lithography.

Optical Lithography:

  • AZ1518: Positive photoresist, thicknesses from 1-4 μm
  • AZ9260: Positive photoresist, thicknesses from 5-20 μm
  • SU-8: Positive resist

Electron Beam Lithography:

  • 950 PMMA A4: Positive resist
  • XR1541 (HSQ): Negative resist

 

Optical Photoresists


General Properties of AZ/Ti Photoresists

AZ1518

Composition

The AZ positive resists consist of a resin (Novolak), a photoactive compound or PAC (a DNQ compound), and a solvent (PGMEA).

References:

 

AZ9260

References:

 

Electron Beam Photoresists

950 PMMA A4

Properties

  • Composition: 4% polymethylmethacrylate of average molecular weight 950,000 dissolved in anisole.
  • Positive tone.
  • Refractive Index: 1.49-1.52 at 632.8nm.
    Pros:
  • Good adhesion to most substrates
  • Very high resolution (down to 10 nm).
  • Long shelf life and spun film life
  • Insensitive to white light
  • Resistant to water, IPA/Methanol, TMAH based developers, and dilute acids for short periods
    Cons:
  • Poor etch resistance for dry etching
  • Low contrast
  • Attacked by acetone, HF, Piranha.

Manufacturer recommended process: (summarized from Microchem PMMA Data Sheet)

  1. Solvent clean of substrate.
  2. Dispense 5 - 8 mL for a 150 mm wafer.
  3. Ramp to 500 RPM for 5 s OR let sit without rotation for 10 s.
  4. Quick ramp to spin speed, holding for 45 s.
  5. Prebake on hot plate at 180 C for 60-90 s.
  6. Expose with dose between 50-500 μC/cm2 depending on equipment and polymer.
  7. Development: For high resolution, 1:3 MIBK to IPA for 60-120 s. Rinse in IPA or DI water immediately following develop to prevent scumming. Blow dry.
  8. (Optional) Postbake: 100 C hot plate for 60-90 s. Note that PMMA will reflow above 125 C.
  9. Removal: Will generally be removed by common positive PR strippers, including acetone. Thorough removal can be accomplished with Remover PG at 50-60 C.

 

Notes:

Sensitivity of PMMA depends on the concentration, developer used, and accelerating voltage of the exposure (e.g. Rooks 2002) . At 100 kV for our PMMA, developed in 1:3 MIBK/IPA, 700 μC/cm2 may be a good dose for 2D features (Hoole 1997), with small isolated lines requiring a dose >3000 μC/cm2 .

PMMA References:

XR1541 (HSQ)

Properties

References

MicroChemicals Photoresist references:

General Properties of AZ/Ti Photoresists

  • No labels